JournalHow it works
How a refrigerator makes cold, and where the chain slips
A refrigerator that hums along while the milk turns lukewarm has not failed everywhere at once. Cooling is a relay that passes heat from your shelves to the kitchen air, and once you know each hand-off, the symptom in front of you points to the link that slipped.
First published
The short answer first
Why is my refrigerator running but not getting cold?
Because a running motor only proves there is power. Cold depends on heat leaving the cabinet, and that can stall at several points: a condenser coil smothered in dust, a fan that quit, an evaporator locked in frost, vents hidden behind food, a tired door seal or refrigerant slowly escaping. Most of these are repairable without replacing the unit.
How cold is made, one hand-off at a time
A refrigerator never pumps cold in. It hauls heat out with a sealed loop of refrigerant and a couple of fans, whether it is a plain freestanding model or a paneled Sub-Zero column.
-
The compressor squeezes
The part you hear humming presses refrigerant vapor into a hot, high-pressure gas.
-
The condenser lets heat go
Behind the grille, a fan drags kitchen air across the condenser coil, the gas sheds its heat and turns liquid. Lint on those fins works like a wool blanket.
-
The pressure drops
The liquid squeezes through a narrow passage into the evaporator and boils far below freezing.
-
The evaporator soaks up warmth
A small fan pushes cabinet air through the frigid evaporator fins and sends it back to the shelves through vents.
-
Defrost keeps the coil open
Moisture from food and door openings freezes on the evaporator; a heater melts it on a cycle so air keeps flowing.
Why a humming fridge can still be warm
Read the loop again and the puzzle mostly disappears. The compressor needs nothing but electricity to run, so it can labor nonstop while the heat stays put. Carrying heat away also takes a clean condenser, two working fans, an evaporator free of ice, a door that seals and a full charge of refrigerant. Lose one and the unit just runs longer, chasing a number it can no longer reach.
That is why the trouble creeps in. Lint on the condenser adds a little strain each week, and an evaporator that cannot defrost grows a thicker shell until the air stops moving. Humid summers in Westmont or Downers Grove load a dusty coil even more, which is why our seasonal calendar puts the condenser first.
Many Sub-Zero units add a twist. Their Dual Refrigeration design gives the refrigerator and the freezer individual systems, so the freezer never dries out the fresh-food air and fresh-food smells stay away from the ice. On 200 and 300 Series combination units, count the 1s in the model number: each is one compressor and control. A 361RFD has one, a 3211RFD has two, and model 211 is the exception with one. PRO Series units split it three ways, giving the main refrigerator, its drawers and the freezer their own control on the two touch displays on the grille, so read those displays before you suspect a part.
Match what you see to the weak link
These pairings are where a technician begins the search, not a final verdict.
- Compressor never seems to rest, the grille area feels hot
- Condenser coil packed with dust or its fan stalled Related service
- White frost coating the rear wall or vents of the freezer
- Defrost heater, sensor or control no longer clearing the evaporator Related service
- Hum starts, stops and clicks every few minutes while both sides lose cold
- A start relay or a compressor that cannot keep itself running Related service
- Warm pockets near the door, moisture beading on the cabinet face
- Gasket not sealing, or a heavy wood panel dragging the door out of line Related service
- Fans spin, coils are clean, settings are right, cooling stays weak
- Refrigerant leak or restriction inside the sealed system
Cold freezer, warm refrigerator
Why is my freezer cold but my refrigerator not cold?
In most single-system refrigerators the fresh-food side has no coil of its own. It borrows chilled air from the freezer coil through a fan and a vent or damper, so a failed fan, an iced-over coil or a stuck damper leaves the freezer fine and the shelves warm. On a two-system Sub-Zero, the refrigerator side's own compressor, fan and control are the suspects.
One shared system
- One compressor and one evaporator serve both compartments
- A frosted coil or dead fan can warm the refrigerator while the freezer holds
- Fresh-food air crosses a freezing coil, which dries produce
Sub-Zero Dual Refrigeration
- Individual systems for the refrigerator and the freezer
- A fault tends to show on one side only
- Fresh-food air keeps its moisture, and its odors stay out of the ice
Knowing which design you own cuts the search in half.
What an owner can safely check
What should I check first when my fridge is not cooling?
Begin with checks that need no tools. Confirm the displays show the settings you expect, pull food back from the vents, make sure every door closes and seals evenly, and with the breaker off, clear dust from the condenser behind the grille. If the shelves are still warm by the next morning, book a technician.
- Air inside: leave space around the vents and between containers so cold air reaches the corners.
- Air outside: with the breaker off, brush loose dust and pet hair off the condenser without bending the fins.
- Door seal: run a hand around each closed door for a cool draft and look for torn or flattened gasket spots.
- A true reading: stand a thermometer in a cup of water mid-cabinet overnight; food-safety guidance puts the line at 40°F or colder.
- Frost: a white coat on the freezer's back panel points to defrost rather than a setting.
Leave these to a technician
The refrigerant in current Sub-Zero units is flammable, and the maker's own use and care guides reserve work on it for refrigeration technicians with flammable-refrigerant training. The charge is small: the safety standard for household units using R-600a or R-290 allows at most 150 grams (5.29 ounces) per refrigerant circuit, so even a slow leak leaves a system short.
- Hissing, oily marks near the tubing or a sharp chemical odor: keep the panels closed and call.
- Burning smell, smoke or sparks: switch the unit off at the breaker and keep wet hands away.
- Meanwhile keep the doors shut and see the emergency page for protecting food.
More questions about a fridge that won't cool
- How can I tell whether my Sub-Zero has one cooling system or two?
- Look for the serial tag, which carries the model as well. Over-and-under Classic (BI, CL), 600, 500 and 200/300 Series units have it just inside the refrigerator door, up by the top hinge. Side-by-side models put it on the freezer door's inner side, Classic French-door units on the left door. Our model guide explains the generations.
- Is it the thermostat or the compressor?
- Often neither. Dusty coils, stalled fans, iced evaporators and leaky gaskets cause far more warm cabinets. A careful diagnosis checks those simpler links first, then the control and its sensors, and opens the sealed system last.
- The freezer has warmed too and ice has nearly stopped. Is that connected?
- Almost certainly, since the ice maker depends on the freezer side. Once the cold is back, a Sub-Zero in-unit ice maker makes 64-96 cubes a day and stops when the bin is full, so an empty bin can take 2 days to fill. Ice-only faults are on our ice maker service page.
- What does a visit cost when the refrigerator is not cooling?
- The service call is $89: one charge per house call, however many Sub-Zero units the technician examines, credited toward the repair when you go ahead. The repair price is quoted after the inspection.
- The refrigerator went warm late in the evening. What should I do until morning?
- Keep both doors closed, since every look lets cold out. Phone (312) 651-6937; the line is answered 24/7, and house calls run daily, 8 AM–6 PM.